BQXFH - S-515 CLEAR THIN-SPREAD ADHESIVE

Product Identification

Product ID:S-515 CLEAR THIN-SPREAD ADHESIVE
MSDS Date:10/21/1992
FSC:8040
NIIN:00N038168
MSDS Number: BQXFH

Responsible Party
ARMSTRONG WORLD INDUSTRIES INC
313 WEST LIBERTY ST
LANCASTER, PA 17604
US

Emergency Phone: 717-396-2328

Info Phone: 717-396-2935

Cage: 03938

Contractor
ARMSTRONG WORLD INDUSTRIES, INC.
3209 LANCASTER, PA 17604 US

Telephone: 717-396-2328; 717-396-2935

Cage: 03938

Ingredients

BENZIN; (VM & P NAPHTHA)

CAS: 8030-30-6

RTECS: DE3030000

Fraction By Weight: 2%

OSHA PEL 300 PPM;400 STEL

ACGIH TLV: 300 PPM


TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 2 - 8%

OSHA PEL 200 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:NOTE: TOLUENE CAS #108-88-3 APPEARS ON
THE NAVY LISTING OF OCCUPATIONAL CHEMICAL REPRODUCTIVE HAZARDS.
SEEK CONSULTATION FROM APPROPRIATE HEALTH PROFESSIONALS ABOUT
LATEST HAZARD LIST INFORMATION & SA FE HANDLING & EXPOSURE
RECOMMENDATIONS . TARGET ORGANS: UPPER RESPIRATORY TRACT, SKIN,
EYES. (EFTS OF OVEREXPOS)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: SKIN & EYES: EXCESS SKIN CONT MAY
CAUSE DRYING & CRACKING OF SKIN, DEFATTING OF TISS, & RSLT IN DERM.
CONT W/EYES WILL CAUSE IRRIT. INHAL:VM&P NAPHTHA & TOLUENE ARE
KNOWN TO CAUSE IRRIT OF R ESP TRACT, COUGHING & CNS EFFECTS SUCH AS
HEADACHE, DIZZINESS, DROWSINESS, NAUSEA, UNCOORDINATED MOVEMENTS.
Medical Cond Aggravated by Exposure:ANY CONDITION GENERALLY AGGRAVATED
BY SOLVENTS, INCLUDING PREEXISTING UPPER RESPIRATORY AND LUNG
DISEASE SUCH AS, BUT NOT LIMITED TO BRONCHITIS, EMPHYSEMA, AND
ASTHMA. EXISTING SKIN CONDITION.

First Aid

First Aid:EYES:FLUSH W/PLENTY OF WATER FOR @ LST 15 MIN & GET IMMED MED
ATTN. REFER TO MD IF IRRIT/SYMPS PERSIST. SKIN: FLUSH W/PLENTY OF
WATER FOR @ LST 15 MIN & GET IMMED MED ATTN. WASH W/SOAP & WATER.
REFER TO MD IF IRRIT/SYMPS PERSIST. INHAL: REMOVE TO FRESH AIR IF
EXPOSED TO EXCESS CONC OF VAP. SEEK MED ATTN IF SYMPS PERSIST.
INGEST: DO NOT INDUCE VOMIT. CALL POISON CONTROL CENTER/MD FOR
GUIDANCE.

Fire Fighting

Flash Point Method:SCC
Flash Point:>210F,>99C
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, HALON, WATER SPRAY.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS IN A FIRE MAY RUPTURE
DUE TO PRESSURE BUILD-UP; USE WATER TO COOL CONTAINERS TO PREVENT
THIS.

Accidental Release

Spill Release Procedures:VENTILATE AREA OF SPILL OR RELEASE. WEAR EYE
PROTECTION EQUIPMENT. SCRAP UP PRODUCT AND PLACE INTO CONTAINER.
RESIDUAL OF PRODUCT, WHILE STILL WET, CAN BE CLEANED UP WITH WARM
SOAPY WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE IN AN AREA SUITABLE FOR
COMBUSTIBLE MIXTURES. RECOMMENDED STORAGE TEMPERATURE IS BELOW 90F.
Other Precautions:VAPORS ARE HEAVIER THAN AIR. USE PRECAUTIONS THAT ARE
COMMON WITH THE SAFE HANDLING OF COMBUSTIBLE LIQUIDS.

Exposure Controls

Respiratory Protection:WITH ADEQUATE VENTILATION, RESPIRATORY EQUIPMENT
SHOULD NOT BE NEEDED. IF ADEQUATE VENTILATION IS NOT AFFORDED, WEAR
NIOSH/MSHA APPROVED RESPIRATORY EQUIPMENT APPROVED FOR ORGANIC
VAPORS.
Ventilation:USE NATURAL CROSS-VENT, LOC (MECH) PICK-UP, &/GEN AREA
(MECH) VENT TO PVNT AN ACUUMULATION OF SOLV VAPS, (SUPP DATA)
Protective Gloves:COTTON/LOOP-PILE GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
VENT: KEEPING IN MIND THAT THE VENTILATION PATTERN MUST REMOVE THE
HEAVIER THAN AIR SOLVENT VAPORS FROM THE LOWER LEVELS OF THE WORK
SPACES. THE VENTILATION SHOULD BE SUFFICIENT TO KEEP THE SOLVENT VA
POR CONCENTRATION BELOW THE TLV.

Chemical Properties

Boiling Pt:B.P. Text:>210F,>99C
Vapor Density:HVR/AIR
Solubility in Water:APPRECIABLE
Appearance and Odor:CLEAR ADHESIVE WITH SLIGHT AROMATIC ODOR.

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE &
OTHER TOX VAPS & GASES THAT ARE COMMON TO THERMAL DEGRADATION OF
ORGANIC COMPOUNDS.

Disposal

Waste Disposal Methods:INCINERATION/OTHER APPROVED METHOD I/A/W FED,
STATE & LOCAL REGS. PROD CONTAINS CHEMS SUBJECT TO REPORTING REQMTS
OF SECTION 313 OF TITLE III OF THE SUPERFUND AMENDMENT &
REAUTHORIZATION ACT OF 1986 A ND 40 CFR PART 372.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.